Netgear M4100-26G CLI Manual - Page 276

ProSafe M4100 and M7100 Managed Switches Format Mode distance ospf {intra-area | inter-area | external } Router OSPF Config no distance ospf This command sets the default route preference value of OSPF routes in the router. The type of OSPF can be intra, inter, or external. All the external type routes are given the same preference value. Format Mode no distance ospf {intra-area | inter-area | external} Router OSPF Config distribute-list out (OSPF) Use this command to specify the access list to filter routes received from the source protocol. Format Mode distribute-list out {rip | static | connected} Router OSPF Config no distribute-list out Use this command to specify the access list to filter routes received from the source protocol. Format Mode no distribute-list out {rip | static | connected} Router OSPF Config exit-overflow-interval (OSPF) This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering overflow state that a router will wait before attempting to leave the overflow state. This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router will not leave overflow state until restarted. The range for seconds is 0-2,147,483,647 seconds. Default Format Mode 0 exit-overflow-interval Router OSPF Config no exit-overflow-interval This command configures the default exit overflow interval for OSPF. Format Mode no exit-overflow-interval Router OSPF Config Routing Commands 276