Netgear M4100-26G CLI Manual - Page 21

ProSafe M4100 and M7100 Managed Switches Port Configuration Commands This section describes the commands you use to view and configure port settings. interface This command gives you access to the Interface Config mode, which allows you to enable or modify the operation of an interface (port). Format Mode interface Global Config interface vlan This command gives you access to the vlan virtual interface mode, which allows certain port configurations (for example, the IP address) to be applied to the VLAN interface. Type a question mark (?) after entering the interface configuration mode to see the available options. Format Mode interface vlan Global Config interface lag This command gives you access to the LAG (link aggregation, or port channel) virtual interface, which allows certain port configurations to be applied to the LAG interface. Type a question mark (?) after entering the interface configuration mode to see the available options. Note: The IP address cannot be assigned to a LAG virtual interface. The interface must be put under a VLAN group and an IP address assigned to the VLAN group. Format Mode interface lag Global Config auto-negotiate This command enables automatic negotiation on a port. Default Format Mode enabled auto-negotiate Interface Config Switching Commands 21