Netgear M4100-26G CLI Manual - Page 191

ProSafe M4100 and M7100 Managed Switches show lldp med remote-device This command displays summary information about remote devices that transmit current LLDP MED data to the system. You can show information about LLDP remote data received on all ports or on a specific port. Format Mode show lldp med remote-device { | all} Privileged EXEC Term Interface Device Class Definition The interface in a slot/port format. The Remote device's MED Classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic [IP Communication Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone etc]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc. Example: The following shows example CLI display output for the command. (Switch) #show lldp med remote-device all LLDP MED Remote Device Summary Local Interface --------- 0/8 0/9 0/10 0/11 0/12 Remote ID --------- 1 2 3 4 5 Device Class Class I Not Defined Class II Class III Network Con show lldp med remote-device detail Use this command to display detailed information about remote devices that transmit current LLDP MED data to an interface on the system. Format Mode show lldp med remote-device detail Privileged EXEC Term Supported Capabilities Enabled capabilities Definition Shows the supported capabilities that were received in MED TLV on this port. Shows the enabled capabilities that were enabled in MED TLV on this port. Switching Commands 191