Netgear M4100-26G CLI Manual - Page 604
sFlow Commands, cablestatus, sflow receiver
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 604 highlights
ProSafe M4100 and M7100 Managed Switches cablestatus This command returns the status of the specified port. Format Mode cablestatus Privileged EXEC Field Cable Status Cable Length Description One of the following statuses is returned: • Normal: The cable is working correctly. • Open: The cable is disconnected or there is a faulty connector. • Short: There is an electrical short in the cable. • Cable Test Failed: The cable status could not be determined. The cable may in fact be working. If this feature is supported by the PHY for the current link speed, the cable length is displayed as a range between the shortest estimated length and the longest estimated length. Note that if the link is down and a cable is attached to a 10/100 Ethernet adapter, then the cable status may display as Open or Short because some Ethernet adapters leave unused wire pairs unterminated or grounded. Unknown is displayed if the cable length could not be determined. sFlow Commands sFlow® is the standard for monitoring high-speed switched and routed networks. sFlow technology is built into network equipment and gives complete visibility into network activity, enabling effective management and control of network resources. sflow receiver Use this command to configure the sFlow collector parameters (owner string, receiver timeout, max datagram size, IP address, and port). Format Mode sflow receiver owner [timeout | notimeout] max datagram ip/ipv6 port Global Config Utility Commands 604