Netgear M4100-26G CLI Manual - Page 701
Switch Database Management (SDM) Templates, set clibanner, sdm prefer
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 701 highlights
ProSafe M4100 and M7100 Managed Switches set clibanner Use this command to add the CLI Banner. The banner message supports up to 2000 characters. Format Mode set clibanner Global Config no set clibanner Use this command to remove the CLI Banner downloaded through TFTP. Format Mode no set clibanner Global Config Switch Database Management (SDM) Templates You can use SDM templates to configure system resources in the switch and optimize support for specific features depending on how the switch is used in the network. You can select a template to provide the maximum system usage for a specific function. For example, you could use a routing template to optimize resources for IPv4 routing if the network environment does not use IPv6 routing. Note the following: • If you configure an SDM template, you must reload the switch for the configuration to take effect. • If you try to configure IPv6 routing without first selecting the dual IPv4-IPv6 routing template, a warning message appears. sdm prefer Use this command to specify the SDM template to use on the switch. Default Format Mode ipv4-routing for IPv4 only builds, dual-ipv4-ipv6 for IPv6 builds sdm prefer {ipv4-routing {default | data-center} | dual-ipv4-and-ipv6 {default}} Global Config Management Commands 701