Netgear M4100-26G CLI Manual - Page 425
ipv6 pim hello-interval, show ipv6 pim, no ipv6 pim Interface Config
View all Netgear M4100-26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 425 highlights
ProSafe M4100 and M7100 Managed Switches no ipv6 pim (Interface Config) Use this command to set the administrative mode of PIM on an interface to disabled. Format Mode no ipv6 pim Interface Config ipv6 pim hello-interval Use this command to configure the PIM hello interval for the specified router interface. The hello-interval is specified in seconds and is in the range 10-18000. Default Format Mode 30 ipv6 pim hello-interval Interface Config no ipv6 pim hello-interval Use this command to set the PIM hello interval to the default value. Format Mode no ipv6 pim hello-interval Interface Config show ipv6 pim Use this command to display PIM Global Configuration parameters and PIM interface status. Format Mode show ipv6 pim • Privileged EXEC • User EXEC Term Definition PIM Mode Configured mode of PIM protocol Data Threshold Rate Rate (in kbps) of SPT Threshold Register Rate-limit Rate (in kbps) of Register Threshold Interface Valid unit, slot, and port number separated by forward slashes Interface-Mode Indicates whether PIM-DM is enabled or disabled on this interface Operational-Status The current state of PIM-DM on this interface. Possible values are Operational or Non-Operational. Example: The following shows example CLI display output for the command. (Switch) #show ipv6 pim IPv6 Multicast Commands 425