D-Link DGS-6600-48T Product Manual - Page 162

DGS-6604 mm Examples distance If the distances for specific routes are not specified, the distances of the routes learned by a routing protocol follows the distance of the routing protocol. In the current configuration, there is a difference between RIP and RIPng. 1. The specified network prefix means the interface address for RIP. 2. The specified network prefix means the specific routes for RIPng. If the distances for specific routes are specified, the distances of the routes are set to the specified value. If the switch is operated at multi-path disabled mode, then the route with the lowest distance will be established as the active route. If the route that is found has failed, then this route will be automatically deactivated and the route with the next lower distance will be the active route. If the switch is operated in the multi-path enabled mode, then routes with the same distances will be active at the same time. Note 1: BGP Protocol does not support this command. Note 2: OSPF does not support the parameter: [NETWORK-PREFIX/PREFIXLENGTH]. This example shows how to set rip distance as 100, and route 30.0.0.0/8 with distance 90 Switch(config)# router rip Switch(config-router)# distance 100 Switch(config-router)# distance 90 30.0.0.0/8 This example shows how to remove the distance configuration of RIP (set to default distance of RIP, 120) and network 30.0.0.0/8 Switch(config)# router rip Switch(config-router)# no distance 100 Switch(config-router)# no distance 90 30.0.0.0/8 Verify the settings by entering the show ip protocols command. CLI Reference Guide 152