D-Link DGS-6600-48T Product Manual - Page 172

DGS-6604 mm dot1x control-direction dot1x control-direction Use this command to configure the direction of the traffic on a controlled port as unidirectional (in) or bidirectional (both). dot1x control-direction { both | in } Syntax Description both Enable bidirectional control. Both incoming and outgoing traffic through an 802.1X-enabled port are blocked if the port is not successfully authenticated. in Enable unidirectional control. Incoming traffic through an 802.1X-enabled port is blocked if the port is not successfully authenticated. Default Command Mode Usage Guideline Example both Interface configuration This command is only valid for physical port interface. This command takes effect only when the global and per-port 802.1x enable command is configured. When the port is in force-unauthorized or un-authorized state, the traffic direction is controlled based on this command. When the port is in force-authorized or authorized state, the traffic is allowed in both directions. The following example shows how to specifies the direction of the traffic through port eth4.1 as unidirectional. Switch# configure terminal Switch(config)# interface eth4.1 Switch(config-if)# dot1x control-direction in Verify the settings by entering the show dot1x auth-configuration command. CLI Reference Guide 162