D-Link DGS-6600-48T Product Manual - Page 867

DGS-6604 m speed speed Use this command to configure the physical port interface speed/duplex setting. speed {10|100|1000[master|slave]|auto} Syntax Description 10 Specifies to set the port speed to transmit at 10 Mbps. 100 Specifies to set the port speed to transmit at 100 Mbps. 1000 Specifies to set the port speed to transmit at 1000 Mbps. • copper port: If the speed is set to 1000 Mbps, then the port must be manually set as either a master or a slave port. master slave auto • fiber port (1000SX/LX): no-negotiation should be configured (i.e. autonegotiation disable). (1000 only) Manually sets a copper port to be the master port. (1000 only) Manually sets a copper port to be the slave port. Specifies to determine the speed through auto-negotiation with its linked partner. • copper port: Specify to determine the speed via auto-negotiation with its linked partner. • fiber port(1000SX/LX): auto-negotiation enable,auto-negotiation will be started to negotiate the clock and flow control. Default Command Mode Usage Guideline It will be auto for 100TX and 1000TX. It will be fixed to 100 for 100FX. It will be fixed to 1000 for 1000SX/LX. Interface configuration Only physical port interfaces are valid for this configuration. If the specified speed is not supported by the hardware, error messages will be returned. 1000SX/LX is always fixed to 1000 and full duplex. 100FX is always fixed 100 and full duplex. For all SFP/XFP modules, duplex command will not take effect. Auto-negotiation will be enabled whether the speed is set to auto or duplex is set to auto. If the speed is set to auto, and duplex is set to fixed mode, then only the speed will be negotiated. The advertised capability will be the configured duplex mode combined with all possible speeds. If speed is to set to a fixed speed and duplex is set to auto, then only duplex mode is negotiated. The advertised CLI Reference Guide 857