D-Link DGS-6600-48T Product Manual - Page 43

DGS-6604 m acceptable-frame acceptable-frame Use the acceptable-frame interface command to set the acceptable frame type of a port for IEEE 802.1Q VLANs. The default acceptable frame type is admit-all. acceptable-frame { tagged-only | untagged-only | admit-all } Syntax Description tagged-only Set acceptable frame type for tagged only of the interface. untagged-only Set acceptable frame type for untagged only of the interface. admit-all Set acceptable frame type for all packets of the interface. Default Command Mode Usage Guideline Example admit-all interface configuration The valid interfaces for this command are physical ports. The acceptable-frame interface command can be used to set the acceptable frame types for physical port interfaces. If an acceptable frame type is taggedonly, only tagged packets of incoming packets will be received by the interface and untagged packets will be dropped. If untagged-only, only untagged packets will be received and tagged packets will be dropped. If admit-all, all packets will be received. This example shows how to set the acceptable frame type to tagged-only of eth3.1. Switch(config)# interface eth3.1 Switch(config-if)# acceptable-frame tagged-only Verify the settings by entering the show vlan interface command. CLI Reference Guide 33