D-Link DGS-6600-48T Product Manual - Page 883

DGS-6604 m telnet teTlnet The telnet command is used to login in another device that supports the TELNET protocol. telnet {IP-ADDRESS | IPV6-ADDRESS} [TCP-PORT] Syntax Description IP-ADDRESS IPv4 address of the host. IPV6-ADDRESS IPv6 address of the host. TCP-PORT Specifies the The TCP port number that telnet should use. TCP ports are numbered between 1 and 65535. The "well-known" TCP port for the TELNET protocol is 23. Default Command Mode Usage Guideline TCP-PORT: 23 Management interface or User EXEC This command starts the telnet client function and can be used to communicate with another device using the TELNET protocol. The telnet command is allowed under both management interface modes and User EXEC mode. For User EXEC mode, the outgoing physical interfaces does not include the management interface. To use telnet in order to login to a device which can be reached only through the management port, use the telnet command under management interface mode by entering the mgmt-if command first. The Telnet software supports special Telnet commands in the form of Telnet sequences that map generic terminal control functions to operating systemspecific functions. To issue a special Telnet command, enter the escape sequence and then a command character. The default escape sequence is Ctrl-_ (press and hold the Ctrl and Shift keys and the '_' key, the underscore). The special Telnet commands will be displayed as follows: Supported commands are: e - terminate the current Telnet session If any other key is pressed, the terminal will return to the original active Telnet session. Use the lowercase letter, 'e' to exit from the telnet software. Several concurrent Telnet sessions can be opened on the switch system and each open Telnet session can have its own telnet client software concurrently supported. Use "ctrl-c" to stop the connection if telnet is connecting but before the session connection is made. CLI Reference Guide 873