D-Link DGS-6600-48T Product Manual - Page 500

DGS-6604 m qos bandwidth qos bandwidth To set the received bandwidth limit values for an interface, use the bandwidth ingress command in interface configuration mode. To set the transmit bandwidth limit values on an interface use the bandwidth egress command in interface configuration mode. To disable bandwidth limit, use the no form of this command. qos bandwidth {egress | ingress} NUMBER-KBPS no qos bandwidth {egress | ingress} Syntax Description NUMBER-KBPS Specifies the number of kilo bytes per second as the limitation on the bandwidth. min: 0KB to max:10MB per second Default Command Mode Usage Guideline Example Disabled Interface configuration Only physical ports are valid for this command. The specified limitation should not exceed the maximum speed of the specified interface. For ingress bandwidth limitation, the ingress will send pause frame or flow control frame when the received traffic exceeds the limitation. In the following example, bandwidth limitations are configured on eth 2.5. The ingress bandwidth is limited to 128 Kbps and the egress bandwidth is limited to 256 Kbps. Switch(config)#interface eth2.5 Switch(config-if)#qos bandwidth ingress 128 Switch(config-if)#qos bandwidth egress 256 Verify the settings by entering the show qos interface bandwidth command. CLI Reference Guide 490