D-Link DGS-6600-48T Product Manual - Page 506

DGS-6604 m qos map cos-color qos map cos-color To define the CoS to color map for mapping of a packet's initial color, use the qos map cos-color command in interface configuration mode. To return the map to default setting, use the no form of this command. qos map cos-color COS-LIST to { green | yellow | red} no qos map cos-color Syntax Description COS-LIST Specifies the list of COS value to be mapped to a color. The range of COS is 0 to 7. The multiple CoS values in the list can be in the form 1, 2,..etc.. separated by commas, a continuous list such as 2-7, or a mixed form 1, 2, 3-5, etc.. Default Command Mode Usage Guideline Example COS-LIST: 0-7 set to green Interface configuration Only Physical port interfaces are supported; portchannel interface and vlan interface are not valid for this command. When a packet entering the ingress port, it will be colored based on either the DSCP to color map (as the port is trust DSP) or CoS to color map (as the port is trust CoS). Use the qos map cos-color command in interface configuration mode to configure the CoS to color map. If the ingress port is trust CoS, the received packet will be initialized to color based on this map. The following example defines CoS 1-7 as red color, 0 as green color at eth 3.1. Switch(config)# interface eth3.1 Swtich (config-if)# qos map cos-color 1-7 to red Verify the settings by entering the show qos interface map command CLI Reference Guide 496