D-Link DGS-6600-48T Product Manual - Page 96

DGS-6604 m class class Use this command to specify the name of the class map in order to define its traffic policy and enter into policy-map class configuration mode. Use the no form of the command to remove the policy definition for the specified class. All the traffic that does not match any defined class will be classified to default class, class-default. class NAME no class NAME class class-default Syntax Description NAME Specifies the name of the class map that the class policy. Up to 32 characters are allowed. Default Command Mode Usage Guideline Examples None Policy-map configuration The class map needs to be created before the policy can be configured for it. A class-map without any match commands cannot be configured as a class policy. This command enters the policy-map class configuration mode. The user can use the set command and police command to define the QoS policy for the class. class-default is the reserved name for the default class. All the traffic that does not match any defined class will be classified to class-default. This example shows how to define a policy map, policy1 which defines policies for class, class-dscp-red. The packet that matches DSCP 10, 12, or 14 will be set to new DSCP 10 and policed by a single rate policer. Switch(config)# class-map class-dscp-red Switch(config-cmap)# match ip dscp 10,12,14 Switch(config-cmap)# exit Switch(config)# policy-map policy1 Switch(config-pmap)# class class-dscp-red Switch(config-pmap-c)# set ip dscp 10 Switch(config-pmap-c)# police 64 128 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)# exit Switch(config-pmap)# exit Verify the settings by entering the show policy-map command. CLI Reference Guide 86