D-Link DGS-6600-48T Product Manual - Page 829

DGS-6604 m ssh ssh To start an encrypted session with a remote networking device, use the ssh command in user EXEC mode. ssh [-c {3des | aes128-cbc | aes256-cbc}] [-m {hmac-md5 | hmac-sha1 | hmac-sha1-96}] [-p PORT-NUMBER] -l USERNAME {IP-ADDRESS | IPV6-ADDRESS} Syntax (Optional)Specifies the crypto algorithm, 3DES, AES128-CBC or AES256-CBC, to -c {3des | aes128-cbc use for encrypting data. | aes256-cbc} If you do not specify the -c keyword, during negotiation the remote networking device sends all the supported crypto algorithms. (Optional)Specifies a Hashed Message Authentication Code (HMAC) algorithm, -m {hmac-md5 | HMAC-MD5, HMAC-SHA1 or HMAC-SHA1-96. hmac-sha1 | hmac- sha1-96} If you do not specify the -m keyword, during negotiation the remote networking device sends all the supported crypto algorithms. -p PORT-NUMBER (Optional) The TCP port number. TCP ports are numbered between 1 and 65535. The "well-known" TCP port for the SSH protocol is 22. -l USERNAME Specifies the USERNAME to use when logging in as on the remote networking device running the SSH server. IP-ADDRESS IPv4 address of the host. IPV6-ADDRESS IPv6 address of the host. Default Command Mode Usage Guideline Example None Management interface mode or User EXEC mode. The ssh command enables a device to make a secure, encrypted connection to another device running an SSH Version 2 server. This connection provides functionality that is similar to that of an outbound Telnet connection except that the connection is encrypted. With authentication and encryption, the SSH client allows for a secure communication over an insecure network. ssh command is allowed under both management interface mode and User EXEC mode. For User EXEC mode, the outgoing physical interfaces does not include management interface. If you are going to use ssh to login a device which can be reached only via the management port, you should use ssh command under management interface mode by entering mgmt-if command first. The following example shows how to ssh to the ip address 20.74.19.200 with default port 22 (optional port parameter is provided). The ip address of 20.74.19.200 is management interface which allows user to long in. CLI Reference Guide 819