D-Link DGS-6600-48T Product Manual - Page 446

DGS-6604 m neighbor send-community neighbor send-community Use this command to specify that the communities attribute should be sent to a BGP neighbor, use the no form of this command to remove the entry. neighbor { IP-ADDRESS | PEER-GROUP-NAME } send-community [both | standard | extended] no neighbor { IP-ADDRESS | PEER-GROUP-NAME } send-community [both | standard | extended] Syntax Description IP-ADDRESS Specifies IP address prefixes. PEER-GROUP-NAME Name of a Border Gateway Protocol (BGP) peer group. both (Optional) Specifies that both standard and extended communities will be sent. standard (Optional) Specifies that only standard communities will be sent. extended (Optional) Specifies that only extended communities will be sent. Default Command Mode Usage Guideline Example None Address family configuration Router configuration When a BGP peer group is specified using the PEER-GROUP-NAME argument, then all the members of the peer group inherit the characteristics configured with this command. The following example, using the address family configuration mode, sets the send-community with the both option (standard and extended): Switch(config)# router bgp 65100 Switch(config-router)# address-family ipv4 Switch(config-router-af)# neighbor 10.4.4.4 send-community both Verify the settings by entering the show ip bgp neighbor command. CLI Reference Guide 436