D-Link DGS-6600-48T Product Manual - Page 438

DGS-6604 m neighbor (RIP IPv6) neighbor (RIP IPv6) To define a neighboring router with which to exchange routing information, use the neighbor command in router configuration mode. Use the no form of the command to remove an entry. neighbor IPv6-ADDRESS IFNAME no neighbor IPv6-ADDRESS IFNAME Syntax Description IPv6-ADDRESS IPv6 link-local address of a router with which routing information will be exchanged. IFNAME The specified interface type and interface number Default Command Mode Usage Guideline Example Not configured Router configuration This command permits the point-to-point exchange of routing information. Multiple neighbor commands can be used to specify additional neighbors or peers. When it is used in combination with the passive-interface router configuration command, routing information can be exchanged between a subset of routers and access servers on a LAN. In the following example, RIPng updates are sent to a specified interface vlan1 on fe80::1. This command permits routing updates to be sent to specific neighbors. One copy of the routing update is generated per neighbor: Switch# configure terminal Switch(config)# router ipv6 rip Switch(config-router)# neighbor fe80::1 vlan1 Verify the settings by entering the show ipv6 rip database command CLI Reference Guide 428