D-Link DGS-6600-48T Product Manual - Page 218

DGS-6604 hybrid vlan VLAN-ID hybrid vlan VLAN-ID Use the hybrid VLAN command to set the VLAN characteristic. It sets the interface as a tagged member or untagged member. hybrid vlan VLAN-ID tagged | untagged } no hybrid vlan [ VLAN-ID [ , | - ] ] Syntax Description VLAN-ID Specifies the VLAN to add or remove tagging member from it. tagged Specifies the port as a tagged member of specified VLAN(s). untagged Specifies the port as an untagged member of specified VLAN(s). , (Optional) Specifies a series of VLANs, or separate a range of VLANs from a previous range. Enter a space before and after the comma. - (Optional) Specifies a range of VLANs. Enter a space before and after the hyphen. Default The default hybrid-vlan is empty. Command Mode Usage Guideline Example Interface configuration Physical ports or port-channels are valid interfaces for this command. By setting the hybrid VLAN command multiple times, a port can be a tagged member port or an untagged member port of multiple VLANs. If the VLAN does not exist, an error message is returned. When this command is applied, the port will change to hybrid mode. If the mode is changed, the setting for the previous mode will disappear. If a VLAN has already been defined as a tagged VLAN, applying this command in untagged VLAN mode will remove that membership. If a VLAN has already been defined as a un-tagged VLAN, applying this command in tagged VLAN mode will remove that membership. When using the no hybrid vlan command without specifying a VLAN ID, then the port's membership will be removed from all VLANs. This example shows how to set an interface port 3.1 as a tagged member of VLAN 1000. Switch(config)# interface eth3.1 Switch(config-if)# hybrid vlan 1000 tagged Verify the settings by entering the show vlan command. CLI Reference Guide 208