D-Link DGS-6600-48T Product Manual - Page 47

DGS-6604 m address-family ipv4 address-family ipv4 Use this command to enter address family configuration mode to configure a routing session using standard IP Version 4 address prefixes. Use the no form of this command to remove the IPv4 address family configuration from the running configuration. address-family ipv4 [unicast ] no address-family ipv4 [unicast] Syntax Description unicast (Optional) Specifies IP Version 4 unicast address prefixes. Default Command Mode Usage Guideline Example Unicast prefix support is enabled by default when this command is entered without any optional keywords. Router configuration Routing information for address family IPv4 unicast is advertised by default for each BGP routing session configured with the neighbor remote-as command unless the no bgp default ipv4-unicast command is used before configuring the neighbor remote-as command. For all settings configured for IPv4 unicast, the settings also appear in BGP router configuration mode. That is, for address-family associated settings, the settings defined in IPv4 unicast address family mode is equivalent to the settings defined in the router configuration mode. To leave address family configuration mode and return to router configuration mode without removing the existing configuration, enter the exit command. This example shows how to enter address family configuration mode for the IP Version 4 address family: Switch(config)# router bgp 65100 Switch(config-router)# address-family ipv4 Switch(config-router-af)# exit Switch(config-router)# CLI Reference Guide 37