D-Link DGS-6600-48T Product Manual - Page 521

DGS-6604 m remote-span remote-span Use the command to specify a VLAN as a RSPAN VLAN. Use the no form of the command to revert to a non RSPAN VLAN. remote-span no remote-span Syntax Default Command Mode Usage Guideline Example Not applicable 802.1q VLAN VLAN config mode Use the remote-span command in vlan config mode to specify a VLAN as a RSPAN VLAN. When a VLAN is specified as a RSPAN VLAN, the access member port of the VLAN will become inactive. The MAC address learning on the RSPAN VLAN is disabled. Use the command in the source switch, middle switch and the destination switch involved in the RSPAN session. For the middle switch involved in a RSPAN session, the port that the monitored packet arrives from and the port that the monitored packets will be sent out need to configured as tag member port of the RSPAN VLAN. This example assigns VLAN 100 as the RSPAN VLAN in the middle switch of RSPAN session. Supposed that eth3.1 is where the monitored packets arrive and eth3.5 is where the monitored packet is transmitted. Switch(config)# interface eth3.1 Switch(config-vlan)# trunk allowed-vlan 100 Switch(config-vlan)# exit Switch(config)# interface eth3.5 Switch(config-vlan)# trunk allowed-vlan 100 Switch(config-vlan)# exit Switch(config)# vlan 100 Switch(config-vlan)# remote-span Switch(config-vlan)#exit Switch(config)# You can verify your settings by entering the show vlan command. CLI Reference Guide 511