D-Link DGS-6600-48T Product Manual - Page 63

DGS-6604 m arp arp Use this command to add a static entry in the Address Resolution Protocol (ARP) cache. Use the no arp command to remove a static entry in the ARP cache. arp IP-ADDRESS HARDWARE-ADDRESS no arp IP-ADDRESS HARDWARE-ADDRESS Syntax Description IP-ADDRESS IP address in four-part dotted decimal format corresponding to the local data-link address. HARDWAREADDRESS Local data-link Media Access (MAC) address (a 48-bit address). Default Command Mode Usage Guideline Example No entries are entered in the ARP cache. Global configuration Use the arp command to assign static and permanent entries to the ARP cache entries. The cache is used to store the IP addresses and the corresponding MAC address so that the addresses will not have to be repeatedly resolved. Static and permanent entries are used for devices that exchange data on a regular basis. To remove all non-static entries from the ARP cache, use the clear arp-cache command. This example shows how to add static ARP entry for a typical Ethernet host: Switch(config)# arp 10.31.7.19 0800.0900.1834 Verify the settings by entering the show arp command. CLI Reference Guide 53