D-Link DGS-6600-48T Product Manual - Page 365

DGS-6604 ipv6 route Then we can use the show command to check whether the configured static route works or not. Switch > enable Switch # show ipv6 route IPv6 Routing Table Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF, I - IS-IS, B - BGP C 2177:0:4:141::/64 is directly connected, vlan141 S 2177:0:3:134::/64 [1/0] via 2177:0:4:906::8003 Total Entries: 2 entries, 2 routes This example shows how to delete an existing static route. Switch > enable Switch # configure terminal Switch (config) # no ipv6 route 2001:0DB8::/32 vlan 1 fe80::0200:00ff:fe00:a0a0 Configuring a Floating Static Route Default Practical Usage Usually, floating static routes are static routes that are being used to back up dynamic routes learned through configured routing protocols. Normally a floating static route is configured with a higher administrative distance than the dynamic routing protocol it is backing up. As a result, the dynamic route learned through the routing protocol is always used in preference to the floating static route. If the dynamic route learned through the routing protocol is lost, the floating static route will be used in its place. That is an IPv6 floating static route can be achieved through the ipv6 route command with a greater distance number. Additionally, to extend the usability, floating static routes can also be allowed to back up static routes, since each route in a system has its own distance. To establish floating static IPv6 routes, use the ipv6 route command in global configuration mode. To remove a previously configured floating static route, use the no form of this command. No floating static routes are configured. Operators may like to specify the priorities of multiple routes destined for the same network. When multiple routes destined for the same network exist, a network device needs to decide which route should be registered into the routing table. The higher priority routes will be active, while lower priority routes will be backup. The following lists the default priority of available kinds of routes in the system. • LOCAL INTERFACE 0 • STATIC 1 CLI Reference Guide 355