D-Link DGS-6600-48T Product Manual - Page 357

DGS-6604 ipv6 ospf transmit delay ipv6 ospf transmit delay To set the estimated time required to send a link-state update packet on the interface, use the ipv6 ospf transmit-delay command. To return to the default value, use the no form of this command. ipv6 ospf transmit-delay SECONDS [instance-id INSTANCE-ID] no ipv6 ospf transmit-delay [instance-id INSTANCE-ID] Syntax Description SECONDS The interval the router waits before it transmits a packet. The valid setting is 165535. INSTANCE-ID (Optional) Instance identifier. To change this ID, configure the "no" command first. The valid setting is from 0 to 255. Default Command Mode Usage Guideline Example SECONDS: 1 INSTANCE-ID: 0 Interface configuration Before being transmited, Link-State Advertisements (LSAs) in the update packet must have their ages incremented by the amount specified in the seconds. The value assigned should take into account the transmission and propagation delays for the interface. If the delay is not added before transmission over a link, the time in which LSAs propagate over the link will not be considered. This setting has more significance on very low-speed links. The following example sets the transmit delay value to 3 seconds. Switch > enable Switch # configure terminal Switch (config) # interface vlan1 Switch (config-if)# ipv6 ospf transmit-delay 3 CLI Reference Guide 347