D-Link DGS-6600-48T Product Manual - Page 843

DGS-6604 m Example snmp-server host will be sent in trap protocol data unit (PDU). For V3 SNMP, the notification will be sent in the SNMPv2-TRAP-PDU with the SNMPv3 header. If the user specifies to send the notification in V3 format, the user can further specify whether to perform authentication and encryption of the packet. The switch will use the community string specified for this command as the user name and look up in the user table to get the password for the authentication and encryption. For both V1/V2 and V3 SNMP, the switch will find out the notification view for the group associated with this SNMP host. If the binding variables associated with this notification are out of this notification view, then this notification will not send to the host. For V3 SNMP host, the argument of WORD refers to a user created by the "snmp-server user" command. For V1/V2 SNMP host, the community string can only be created by the "snmp-server community" command. If the host version is not specified, the default value (SNMP v1) will be adopted and the WORD option must be a community string. There will be an error message displayed if user inputs a user name as WORD option. To create an SNMP host, the community string (for user) must be created first. An error message will be generated to indicate if it is not created. If the host version is diffrent from the group version defined for the host (from the access control list option in the command "snmp-server group"), it will fail because the bersion is not matched. If the community is created, the system will create V1/V2 group implicitly. This example shows how to set up the trap recipient as 163.10.50.126 by using version 3 with security level: auth (MD5 and/or SHA packet authentication) and the SNMPv3 user: authuser. Switch(config)# snmp-server user authuser authgroup v3 auth md5 1234 Switch(config)# snmp-server host 163.10.50.126 version 3 auth authuser This example shows how to set up the trap recipient for IPv6 link-local address as fe80::64:84:154 by using version 2 with security level. The community string: public and this link-local address will be specifies output the vlan-interface: vlan1. Switch(config)# snmp-server host fe80::64:84:154 version 2c public vlan1 You can verify your settings by entering the show snmp host command. CLI Reference Guide 833