D-Link DGS-6600-48T Product Manual - Page 203

DGS-6604 m erpi timer erpi timer Use the erpi timer command to configure timers for an ERP instance. Use the no form of this command to reset timer to default value. erpi INSTANCE-ID timer [guard MILLI-SECONDS] [hold-off MILLI-SECONDS] [wtr MINUTES] no erpi INSTANCE-ID timer [guard] [hold-off] [wtr] Syntax Description INSTANCE-ID Specifies the identifier of the ERP instance. The valid range is1 to 4095. guard MILLISECONDS Specifies the guard timer in milliseconds. The valid range is 10 to 2000. The value should be a multiple of 10. hold-off MILLISECONDS Specifies the hold-off timer in milliseconds. The valid range is 0 to 10000. The value should be a multiple of 100. wtr MINUTES Specifies the WTR timer in minutes. The valid range is 1 to 12. Default Command Mode Usage Guideline Example The default guard timer is 500 milliseconds. The default hold-off timer is 0. The default WTR timer is 5 minutes. ERPS domain configuration mode Use the command to configure timers for the ERP instance The following example shows how to configure guard timer to "600 ms" of ERP instance 1: Switch(config-erps-domain)# erpi 1 timer guard 600 Switch(config-erps-domain)# The following example shows how to configure guard timer to 700 milliseconds, hold-off timer to 100 milliseconds of ERP instance 1: Switch(config-erps-domain)# erpi 1 timer guard 700 hold-off 100 Switch(config-erps-domain)# The following example shows how to configure WTR timer to 1 minutes of ERP instance 1: Switch(config-erps-domain)# erpi 1 timer wtr 1 Switch(config-erps-domain)# CLI Reference Guide 193