D-Link DGS-6600-48T Product Manual - Page 281

DGS-6604 ip mroute Use this command to create a multicast static route (mroute). Use the no form of this command to delete the route. ip mroute SOURCE-NETWORK { RPF-ADDRESS | Null } [ DISTANCE ] no ip mroute SOURCE-NETWORK ip mroute Syntax Description SOURCE-NETWORK Network address of the multicast source. Format: A.B.C.D/M. RPF-ADDRESS RPF neighbor address for the multicast route. Null Indicates Null interface. When set to Null, the RPF check result will always be failed. DISTANCE (Optional) Specifies whether a unicast route or multicast static route is used for the RPF lookup. Lower distances have preference. If the multicast static route has the same distance as the other RPF sources, the multicast static route takes preference. Default is 0. Range is 0-255. Default Command Mode Usage Guideline Examples DISTANCE: 0 Global configuration This command statically configures where multicast sources are located even when the unicast routing table shows something different. If the RPF-ADDRESS is a PIM neighbor, PIM join, graft, and prune messages are sent to it. The following example configures the multicast data source within network 192.168.6.0/24 to be accessible with the neighbor router 10.1.1.1. Switch(config)#ip mroute 192.168.6.0/24 10.1.1.1 The following example configures the multicast data source within network 192.168.7.0/24 to be accessible with the neighbor router 10.1.1.1 and with the distance value of 100. Switch(config)#ip mroute 192.168.7.0/24 10.1.1.1 100 The following example configures the multicast data source within a network number 192.168.8.0/24 to be discarded. Switch(config)#ip mroute 192.168.8.0/24 null CLI Reference Guide 271