D-Link DGS-6600-48T Product Manual - Page 932

DGS-6604 m vrrp shutdown vrrp shutdown This command is to disable the VRRP of a VRID on an interface. Use the no form of the command to re-activate the VRRP. vrrp VRID shutdown no vrrp VRID shutdown Syntax Description VRID Specifies the virtual router identifier, the number identifying the virtual router that the shutdown is being configured for. The virtual router identifier is configured with the command "vrrp ip" on page 917. Range is from 1 to 255. Default Command Mode Usage Guideline Examples None Interface configuration When a VRRP VRID is being configured using the vrrp VRID ip command, the protocol will be fully operational. Using vrrp shutdown disables the protocol operation for one VRID of an interface. The following example shows how to disable one VRRP VRID 7 on interface vlan1 while retaining the VRRP VRID 8. Switch(config)#interface vlan1 Switch(config-if)#vrrp 7 ip 20.1.1.1 Switch(config-if)#vrrp 7 shutdown Switch(config-if)# Switch(config-if)#vrrp 8 ip 20.1.1.2 Switch(config-if)# The following example shows how to re-activate VRRP protocol on VRID 7 of interface vlan1. Switch(config)#interface vlan1 Switch(config-if)#no vrrp 7 shutdown CLI Reference Guide 922