D-Link DGS-6600-48T Product Manual - Page 184
dot1x timeout, dot1x timeout {quiet-period
View all D-Link DGS-6600-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
DGS-6604 mm dot1x timeout dot1x timeout Use this command to set timeout values for various 802.1X timers. dot1x timeout {quiet-period SECONDS | reauth-period SECONDS | server-timeout SECONDS | supp-timeout SECONDS | tx-period SECONDS } Syntax Description quiet-period SECONDS Number of seconds that the switch remains in the quiet state following a failed authentication exchange with the client. The range is 0 to 65535. reauth-period SECONDS Number of seconds between re-authentication attempts. The range is 1 to 65535 server-timeout SECONDS Number of seconds that the switch will wait when it does not receive notification from the authentication server. The range is 1 to 65535. supp-timeout SECONDS Number of seconds that the switch will wait when it does not receive any notification from the client. The range is 1 to 65535. tx-period SECONDS Number of seconds that the switch waits for a response to an EAP-request/ identity frame from the client before retransmitting the request. The range is 1 to 65535. Default Command Mode Usage Guideline Example quiet-period: 60 seconds reauth-period:3600 seconds server-timeou: 30 seconds supp-timeout: 30 seconds tx-period: 30 seconds Interface configuration This command is only valid for physical port interface. The reauth-period takes effect when re-authentication is configured by the dot1x re-authentication command on page 172. This example sets quiet-period, reauth-period, server-timeout, supp-timeout, and tx-period on eth4.1 to be 20, 1000, 15, 15, and 10 seconds, respectively. Switch# configure terminal Switch(config)# interface eth4.1 Switch(config-if)# dot1x timeout quiet-period 20 Switch(config-if)# dot1x timeout reauth-period 1000 Switch(config-if)# dot1x timeout server-timeout 15 Switch(config-if)# dot1x timeout supp-timeout 15 Switch(config-if)# dot1x timeout tx-period 10 Verify the settings by entering the show dot1x auth-configuration command. CLI Reference Guide 174