Sony MLS-X1 Users Guide - Page 100
Setting Super Mix, Setting a Preset Color Mix, When a wipe is selected
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
For details, see "Setting a Preset Color Mix" (page 100). When a wipe is selected Set the wipe pattern. For details, see "Setting a Wipe" (page 149). When a DME wipe is selected Set the DME wipe pattern. For details, see "Setting a DME Wipe" (page 165). When a clip transition is selected Set the clip transition. For details, see "Setting a Clip Transition" (page 173). Setting Super Mix Set the output levels of the current image and new image at the mid-point of the transition. You can set a value in the range 0% to 100%. This section describes the M/E-1 menu as an example. 1 Open the Home > M/E-1 > Bus/Transition > Transition > Transition Type menu (11109.21). 2 Set the [Super Mix] button in the [Transition Type] group to the on state and set the following parameters. No. Parameter 2 A Gain 3 B Gain Adjustment Background A output level Background B output level Setting a Preset Color Mix Set the color matte to insert in a preset color mix. You can also use the utility 2 bus signal in place of a color matte. This section describes the M/E-1 menu as an example. Preset color mix mode You can set the following modes in a preset color mix. For details, see "Setting the Preset Color Mix Mode" (page 394). Stroke mode: In a preset color mix, the current image switches to the color matte on the 1st stroke, and then switches from the color matte to the new image on the 2nd stroke (normal mode). You can also set a preset color mix so that it executes in one stroke (single mode). Note In bus fixed mode, single mode is selected. One-time mode: Return to the previous transition type when the preset color mix transition is completed. Non-drop key: If a key is inserted in the current image, it is removed by the color matte during the transition, and the key status for after the transition is applied to the new image. You can set a mode that the selected key is not removed by the color matte. 1 Open the Home > M/E-1 > Bus/Transition > Transition > Transition Type menu (11109.21). 2 Set the [Preset Color Mix] button in the [Transition Type] group to the on state. 3 Select an image to insert in the [Preset Color Mix Fill] group. Utility 2 Bus: Utility 2 bus signal For details about selecting a signal, see "Chapter 4 Selecting Signals" (page 81). Flat Color: Color matte When the [Flat Color] button is selected, set the following parameters. No. Parameter 2 Luminance 3 Saturation 4 Hue Adjustment Luminance Saturation Hue 100