Sony MLS-X1 Users Guide - Page 435
Setting a Tally Group, Setting Wiring
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 435 highlights
Setting a Tally Group Setting Wiring You can select a tally group (1 to 8) controlled using NSBus. You can set multiple tally groups. 1 Open the Home > Setup > Router/Tally > Tally > Group Tally menu (19106.21). 2 In the [Tally Group] group, select a tally group (Group 1 to Group 8). 3 Enable/disable the tally using the [NS-Bus Tally Enable] button. On: Enable tally control using NS-Bus. Off: Disable tally control using NS-Bus. You can set output and input connection information (wiring) in NS-Bus space. The wiring settings are common to both parallel tally and serial tally. 1 Open the Home > Setup > Router/Tally > Tally > Wiring menu (19106.22). 2 Select the target wiring to set. To select and set multiple wiring, place a check mark beside the target wiring to set. You can also press the [Select Number(s)] button and enter a wiring number in the numeric keypad window. Note The maximum number of wiring settings that can be set at the same time is 128. 3 Press the [Source] button and enter an address for a source in the numeric keypad window. Note If multiple consecutive wiring settings are selected, consecutive addresses from the entered address are set. 4 Press the [Src Level] button and enter a source level (1 to 8) in the numeric keypad window. 5 Press the [Destination] button and enter an address for a destination in the numeric keypad window. Note If multiple consecutive wiring settings are selected, consecutive addresses from the entered address are set. 6 Press the [Dest Level] button and enter a destination level (1 to 8) in the numeric keypad window. To delete wiring settings Select the target wiring to delete and press the [Delete] button. 435