Sony MLS-X1 Users Guide - Page 186
Playing video device control block, To delete regions outside the playback range, trimming
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
To delete regions outside the playback range (trimming) Press the [Trim] button, check the message, then press [OK]. The region before the set playback start point and the region after the set playback stop point are deleted. Notes • Trimming is disabled when video content is in the following states on any of the frame memory output channels. - Playing - Recalled on a locked frame memory output channel • For content present in content storage, trimmed content is saved as new content with a name having a "_TRM" suffix. The original content is not deleted. For content present in frame memory only, the original content is trimmed and saved in frame memory. It is not saved in content storage. Playing video (device control block) The device control block can be switched to device/frame memory/clip player operation mode for playback control of video. For details about the operation buttons in device/frame memory/clip player operation mode, see "VTR/disk recorder operations" (page 217). Note The buttons used for selecting a frame memory output channel must be assigned to the device control block beforehand. For details about assigning buttons, see "Assigning Control Panel Buttons" (page 402). 1 Press the [DEV] button. The [DEV] button is lit amber, and the operation mode switches to device/frame memory/clip player operation mode. 2 Press the [FM1 CLIP] button. The [FM1 CLIP] button is lit green, and frame memory output channel 1 becomes the target of operations. When group mode is enabled, the buttons for the two combined frame memory output channels are lit. 3 Press the [PLAY] button. The [PLAY] button is lit amber, and playback starts. To stop playback, press the [STOP], [SHTL], [JOG], [CUE], [REW], [FF], or [ALL STOP] button. Video playback operations Operate using the following buttons. Button FM LOOP START TC STOP TC STOP CUE REW PLAY FF VAR JOG SHTL ALL STOP Operation Repeat (loop) playback Set current position as playback start point Set current position as playback stop point Pause playback Move to video playback start point Move to start of video content Playback Move to end of video content Variable-speed playback in variable mode Variable-speed playback in jog mode Variable-speed playback in shuttle mode All stopped To change the playback speed Press the [VAR] button, [JOG] button, or [SHTL] button, then turn the Z-ring. Play back in the normal direction when you turn the Z-ring clockwise, and in the reverse direction when you turn it counterclockwise. [VAR] button: Variable-speed playback in variable mode. The playback speed is in the range -1 to +3 times normal speed corresponding to the angle of the Z-ring. [JOG] button: Variable-speed playback in jog mode. The playback speed corresponds to the speed of rotation of the Z-ring. [SHTL] button: Variable-speed playback in shuttle mode. The playback speed corresponds to the angle of rotation of the Z-ring. Device control block display In the device control block of the ICP-X7000, the display shows the following information. • FILE: Name of recalled content • CRNT: Current playback position timecode (hour:minute:second:frame) • START: Playback start point timecode (hour:minute:second:frame) • STOP: Playback stop point timecode (hour:minute:second:frame) Note The content name is displayed left-justified in ASCII characters only (up to 20 characters). 186