Sony MLS-X1 Users Guide - Page 74

To select multiple items, place a check mark for the target items for operation. Select All checkbox To select or deselect all items, use the Select All checkbox. When there are items selected in a list, a blue square is displayed in the Select All checkbox. To select all items, place a check mark in the Select All checkbox. To deselect all items, clear the check mark from the Select All checkbox. Selecting by entering a list number If a number selection button is displayed below the list, you can enter a list number to select an item. Press the number selection button to display the numeric keypad window. Enter the number of the target item and press [Enter]. When selecting multiple items, use a hyphen or comma to specify numbers. Example: To select list items 1 to 5, enter "1-5". To select list items 1, 3, and 5, enter "1,3,5". Button operations in a list When setting items in a list, operation buttons may be displayed in the list depending on the menu. In this manual, list item button operations use the following convention. Example: Operating a button in the [Tally Assign] row for an item in the list using the Home > Setup > Router/Tally > Tally > Parallel Tally menu (19106.26). 1 Open the Home > Setup > Router/Tally > Tally > Parallel Tally menu (19106.26). 2 Select the target parallel output port to set. 3 Press the [Tally Assign] button and select the type of tally from the pull-down list. When there is only one target item Selection of the item is not required. In step 2 of the procedure above, check that the target item in the list is displayed on the menu screen. If the item is not displayed, move the display position in the list. In subsequent procedure steps, you can configure settings by pressing buttons displayed in the row of the target item. When there are multiple target items In step 2 of the procedure above, place check marks in individual checkboxes or in the Select All checkbox to select target items. Changes to the setting of one of the check marked items will apply the same change in setting to the other target items. Changes to the setting of a parameter in the analog controls section are applied only to the item selected as the target, even if multiple items are selected. Also, you may not be able to change other settings simultaneously. Setting Parameters Pressing a parameter setting button displays an analog controls section on the right side of the menu display area for adjusting parameters. Parameter display button Parameter 1 to 5 buttons Analog controls section This section is comprised by a parameter display button and up to five parameter buttons (numbered 1 to 5 from the top). The target button name/group name to set is displayed on the parameter display button. If there are six or more parameters, a page number ("1/2" or "2/2") is displayed on the parameter display button, and pressing the button switches between page 1 and page 2. The parameter name and current setting value are displayed on each of the parameter 1 to 5 buttons. Pressing a parameter button displays an analog controls window for setting parameters. In this manual, parameter setting operations are represented by the parameter button number and parameter name. For parameters on two pages, the number is in "page number - parameter button number" format. Example: Parameters on one page only No. Parameter 1 Width 2 Position 3 Density Adjustment Width Position Density 74