Sony MLS-X1 Users Guide - Page 206

Setting a Wipe Crop Note When Brick is set, Wipe Crop cannot be enabled. 1 Open the Home > DME > Channel1 > Edge > Wipe Crop menu (15101.22). 2 Set the [Wipe Crop] button to the on state. 3 Press the [Pattern Select] button. A pattern selection window appears. 4 Set the button for the target wipe crop pattern to the on state. Note The wipe crop patterns are the same as wipe pattern numbers 1 to 24 and 304. 5 Press [OK]. To invert the wipe crop area (Invert) You can swap the inner and outer areas of the wipe crop pattern. Set the [Invert] button to the on state. To set the radius of wipe crop pattern corners (Radius) You can set the radius of the four corners when pattern number 304 is selected. Set the [Radius] button to the on state and set the following parameter. No. Parameter 1 Radius Adjustment Corner radius To replicate a wipe crop pattern (Multi) You can replicate a pattern horizontally, vertically, or both up to 63 times. For details about pattern layouts, see "Replicating a wipe pattern (Multi)" (page 159). Set the [Multi] button to the on state and set the following parameters. No. Parameter 1 H Multi 2 V Multi 3 Invert Type Adjustment Number of repetitions of pattern horizontally Number of repetitions of pattern vertically Pattern layout (1 to 4) To set the wipe crop pattern position and size (Position/Size) Set the [Position/Size] button to the on state and set the following parameters. No. Parameter 1 H 2 V 3 Size 5 Pattern Adjustment Horizontal position Vertical position Pattern size Pattern number (1 to 24, 304) To set the aspect ratio of a wipe crop pattern (Aspect) Set the [Aspect] button to the on state and set the following parameter. No. Parameter 1 Aspect Adjustment Aspect ratio • Negative values expand vertically. • Positive values expand horizontally. To rotate a wipe crop pattern (Rotation) In the [Rotation] group, select a rotation type. Angle: Incline a pattern at a fixed angle. Speed: Rotate a pattern at a fixed speed. When the [Angle] button is selected, set the following parameter. No. Parameter 1 Angle Adjustment Inclination angle of pattern • A value of -1.00 corresponds to a rotation of one turn counterclockwise. • A value of +1.00 corresponds to a rotation of one turn clockwise. • A value of 0.00 corresponds to no rotation. When the [Speed] button is selected, set the following parameter. No. Parameter 1 Speed Adjustment Rotation speed of pattern • A value of -100.00 corresponds to 4 revolutions/second counterclockwise rotation. • A value of +100.00 corresponds to 4 revolutions/ second clockwise rotation. • A value of 0.00 corresponds to no rotation (stationary). To add modulation to a wipe crop pattern (Modulation) In the [Modulation] group, select a modulation type. H: Modulate a pattern in the horizontal direction. V: Modulate a pattern in the vertical direction. Set the following parameters. 206