Sony MLS-X1 Users Guide - Page 360
Setting the Startup Mode, Applying Initial Status File Settings, Saving user setup
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 360 highlights
Setting the Startup Mode You can set the startup mode for each of the switcher, frame memory/clip player/SL key, and control panel. Note DMEs are included in the startup mode of the switcher. However, DMEs do not support resume mode. When the switcher is set to resume mode, DMEs start in custom mode. 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 Select the target to set. Select a switcher, frame memory/clip player/SL key, or control panel. 3 Press the [Start Up Mode] button and select a startup mode from the pull-down list. Resume: Resume mode Custom: Custom mode When [Resume] mode is selected, steps 4 and 5 are not required. Note You can set the frame memory/clip player/SL key startup mode only when the switcher is set to resume mode. When the switcher is set to custom mode, frame memory/clip player/SL keys are also set to custom mode (fixed). 4 Press the [Setup] button and select a startup mode from the pull-down list. User: User setup Factory: Factory default setup Note The setup mode cannot be set for frame memory/clip player/SL keys. 5 Press the [Initial Status] button and select an initial status mode from the pull-down list. User: User setup Factory: Factory default setup Note When the switcher is set to [Factory] in custom mode, the initial status mode for frame memory/clip player/ SL keys is also set to [Factory] (fixed). Saving user setup User configured setup data and initial status data are saved in non-volatile memory. For details about saved data, see "Data Saved by [Setup Define] and [Initial Status Define]" (page 528). To save setup data 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 In the [Setup Define] group, select the target to save. Switcher: Switcher Panel: Control panel 3 Check the message, then press [OK]. To save initial status data 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 In the [Initial Status Define] group, select the target to save. Switcher/Content: Switcher and frame memory/clip player/SL key Panel: Control panel 3 Check the message, then press [OK]. Applying Initial Status File Settings You can recall an initial status file to apply the setup status saved in the file, regardless of the startup mode settings. Notes • When the [Load and Recall Initial Status] switch is enabled and an initial status file is saved, the setup status at that point in time is saved. For details about initial status files, see "Chapter 19 File Management" (page 329). • Control panel and DME cannot be set. • You can set frame memory/clip player/SL key only when the switcher setting is enabled. When the switcher setting is disabled, frame memory/clip player/SL keys are set to off (fixed). 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 Select the target to set. Select switcher or frame memory/clip player/SL key. 360