Sony MLS-X1 Users Guide - Page 440
Link Setup, Setting a Cross-Point Button Link, Setting a Cross-Point, Button Link
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 440 highlights
Link Setup 27 Chapter Setting a Cross-Point Button Link You can set the bus link function that links together two buses within the switcher. Setting a Bus Link 1 Open the Home > Setup > Link > Internal Bus Link > Bus Assign menu (19107.11). 2 Select the target link number to set. To select and set multiple link numbers, place a check mark beside the target link numbers to set. To select and set all link numbers, place a check mark in the Select All checkbox. 3 Enable/disable the link using the [Link Enable] switch. On: Enable link. Off: Disable link. 4 Press the [Edit] button for [Controlling Bus]. The [Assign Controlling Bus] window appears. 5 Set the button for the link source bus to the on state. Select a tab to change the bus to display. [M/E-1 to M/E-5] tab: M/E bus [P/P] tab: P/P bus [Aux] tab: AUX bus [FM/DME Util] tab: Frame memory/DME bus Note "M/E-x Transition Program", "M/E-x Sub Transition Program", "P/P Transition Program", and "P/P Sub Transition Program" can only be selected as a link source bus ("M/E-x" is M/E-1 to M/E-5). The link function is enabled at the same time you move the fader lever. 6 Press [OK]. 7 Press the [Edit] button for [Linked Bus]. The [Assign Linked Bus] window appears. 8 Set the button for the link destination bus to the on state. Select a tab to change the bus to display. [M/E-1 to M/E-5] tab: M/E bus [P/P] tab: P/P bus [Aux] tab: AUX bus [Aux as Key] tab: AUX bus (signal assigned to the key side) [FM/DME Util] tab: Frame memory/DME bus Note "Aux 1 as Key" to "Aux 48 as Key" can only be selected as a link destination bus. 9 Press [OK]. 10Press the [Link Table] button and select a link table (Link 1 to Link 8) from the pull-down list. Setting a Link Table 1 Open the Home > Setup > Link > Internal Bus Link > Table V/K Pair Assign menu (19107.12). 2 Display the target link table to set. Select a tab to change the link table (Table 1 to Table 8) to display. The logical V/K pair number and logical V/K pair name are displayed. 3 Select the target logical V/K pair number to set. 440