Sony MLS-X1 Users Guide - Page 143

Setting a CG border The image to embed in the border and the key signal for keying the image are selected on key 1. The border image and the key signal for the image are selected on key 2. 1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Resizer Adjust/DME Select menu (11101.41). 2 Set the [Resizer] button to the on state. 3 Set the [CG Border] button in the [CG Border] group to the on state and set the following parameters. No. Parameter 1 Location X 2 Location Y 3 Size Adjustment Horizontal position Vertical position Size To lock the CG border setting You can lock the position and size of the border image of the CG border. To lock the CG border setting, set the [Frame Pos Lock] button in the [CG Border] group to the on state. Note Locking the CG border setting sets all resizer parameters to the default values, and the settings cannot be changed. Setting Interpolation Processing You can set the number of pixels and the anti-aliasing mode used for interpolation processing. 1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Resizer Process menu (11101.43). 2 Set the [Resizer] button to the on state. 3 In the [Interpolation Mode] group, set the number of pixels to use in interpolation. Multi: Use multi-point interpolation. Linear: Use two-point interpolation. 4 In the [Filter Mode] group, select an anti-aliasing mode. Mode1: Even when the picture is reduced, add compensation so that it can be seen clearly (standard). Mode2: Suppress aliasing when enlarging or reducing the picture (soft). Mode3: Do not suppress aliasing when enlarging or reducing the picture (sharp). Setting Resizer Effects Setting a wide key border 1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Enhanced Effect menu (11101.42). 2 Set the [Resizer] button to the on state. 3 Set the [Dual Rszr Effect] button to the on state. 4 Set the [Wide Key Border] button to the on state and set the following parameters. No. Parameter 1 H 2 V 3 All 4 Soft 5 Density Adjustment Simultaneous adjustment of border width of left and right edges Simultaneous adjustment of border width of top and bottom edges Simultaneous adjustment of border width of top, bottom, left, and right edges Softness of border a) Density of border a) Common to the [Soft] drop shadow parameter. 5 Set the [Border Color] button to the on state and set the following parameters. No. Parameter 1 Luminance 2 Saturation 3 Hue Adjustment Luminance Saturation Hue To add an outline to a wide key border Set the [Outline] button to the on state. Setting a drop shadow 1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Enhanced Effect menu (11101.42). 2 Set the [Resizer] button to the on state. 143