Sony MLS-X1 Users Guide - Page 445
G IP I/F Setup, Displaying 100G IP I/F Setup Information, Setting the Control Protocol
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 445 highlights
100G IP I/F Setup 28 Chapter Displaying 100G IP I/F Setup Information Setting the Control Protocol You can check the status information of each LAN port of the 100G IP interface using the Home > Setup > 100G IP I/F > Status menu (19108.11). The following information is displayed. FEC Type/Link Status: FEC type/link status IP Address/Prefix Length: IP address/prefix length Gateway: Gateway Mac Address: MAC address Note Setup information displayed using this menu cannot be changed. For details, refer to the MLS Manager manual. You can set the control communications protocol for ST 2110 transmission connections. Each box configured in a switcher using MLS manager communicates with the controller independently using the selected protocol. 1 Open the Home > Setup > 100G IP I/F > Controller > Protocol menu (19108.12). 2 In the [Protocol] group, select the protocol. NMOS: NMOS NDCP(LSM): NDCP 3 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 4 Check the message, then press [OK]. Setting the node label You can set the device name exposed to the controller for NMOS/NDCP(LSM). 1 Open the Home > Setup > 100G IP I/F > Controller > Protocol menu (19108.12). 2 Press the [Node Label] button and enter the RDS node name (up to 59 characters) using the keyboard. 445