Sony MLS-X1 Users Guide - Page 207
Video Modifier Effects, Setting Defocus, Setting Sepia
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
No. Parameter 1 Amplitude 2 Frequency 3 Speed Adjustment Amplitude of modulation Frequency of modulation Speed of ripples • Negative values create waves in the down and left directions. • Positive values create waves in the up and right directions. To modify a wipe crop pattern edge (Edge) 1 In the [Edge] group, select a type of edge. Border: Adds a border to a pattern. Soft: Softens the edges of a pattern. Soft Border: Softens a border applied to a pattern. When the [Border] button is selected, set the following parameter. No. Parameter 1 Width Adjustment Border width When the [Soft] button is selected, set the following parameter. No. Parameter 1 Soft Adjustment Edge softness When the [Soft Border] button is selected, set the following parameters. No. Parameter 1 Width 2 Inner Soft 3 Outer Soft Adjustment Border width Softness of inner edge of border Softness of outer edge of border 2 In the [Border Fill] group, select a signal to insert in the border. Flat Color: Single color Ext Video: External input (Ext In) signal When the [Flat Color] button is selected, set the following parameters. No. Parameter 1 Luminance 2 Saturation 3 Hue Adjustment Luminance Saturation Hue Video Modifier Effects This section describes the menu for DME channel 1 as an example. Setting Defocus Note To use the Defocus effect, the DME channel must be set to enhanced function mode. 1 Open the Home > DME > Channel1 > Video Modify > Defocus menu (15101.31). 2 Set the [Defocus] button to the on state and set the following parameters. No. Parameter 1 H 2 V 3 All Adjustment Defocusing in horizontal direction Defocusing in vertical direction Simultaneous defocusing adjustment in horizontal direction and vertical direction 3 In the [Defocus Mode] group, select a signal to which to apply the Defocus effect. Video/Key: Video signal and key signal Video: Video signal only To remove the black level leakage that occurs at the edges of the screen Set the [Clean Defocus] button to the on state. Setting Sepia Note Enabling Sepia disables Mono if it is set. 1 Open the Home > DME > Channel1 > Video Modify > Color Modify menu (15101.32). 2 Set the [Sepia] button to the on state and set the following parameters. No. Parameter 1 Mix Y Adjustment Luminance signal mix amount 207