Sony MLS-X1 Users Guide - Page 369

2 Select the target input to set. To select and set multiple inputs, place a check mark beside the target inputs to set. 3 Set the [CCR/HDR] switch to the on state. Setting a Frame Delay 1 Open the Home > Setup > System > Input > Input Adjust menu (19101.31). 2 Select the target input to set. To select and set multiple inputs, place a check mark beside the target inputs to set. To select and set all inputs, place a check mark in the Select All checkbox. 3 Set the [Frame Delay] switch to the on state. To disable a frame delay, set the [Frame Delay] switch to the off state. 4 Press the button on the right of the [Frame Delay] switch and enter a delay value (1 to 4 frames) in the numeric keypad window. Note Ancillary data is deleted from signals for inputs configured with a frame delay. Setting a Format Converter You can use a format converter on odd-numbered inputs. Setting the conversion format You can set the signal format of an input signal to convert by the format converter. Notes • Field frequency and frame frequency conversion is not supported. • Ancillary data is deleted if a conversion format is configured that is different from the system format. • When receiving IP signals, adjacent ports may be affected if the adjacent input ports are in the following states. - When a signal is input that is different from the input format converter setting - When the input format converter setting is changed - When one input signal is disconnected while the same signal source is being input The following ports are affected, depending on the signal format of the system. - 2160P: Affected in units of 2 ports. [1ch-2ch] [3ch-4ch] ... [143ch-144ch] - 1080P, 1080i: Affected in units of 4 ports. [1ch-4ch] [5ch-8ch] ... [157ch-160ch] The signal formats that can be converted are given below. System signal format (frequency) 2160P 2SI (59.94, 50) 1080P (59.94, 50) 1080i (59.94, 50) Signal format of input signal 1080i 1080P 2160P 2SI 720P 1080i 1080P 720P 1080i 1 Open the Home > Setup > System > Input > FC Format menu (19101.32). 2 Select the target input to set. To select and set multiple inputs, place a check mark beside the target inputs to set. To select and set all inputs, place a check mark in the Select All checkbox. 3 Press the [FC Format] button and select an input signal format from the pull-down list. Adjusting the conversion method The conversion method adjustment items and the target conversion formats are given below. Adjustment item Up-converter conversion mode I/P converter conversion mode Conversion format • 1080i t 2160P • 1080i t 1080P 1 Open the Home > Setup > System > Input > FC Adjust menu (19101.33). 2 Select the target input to set. To select and set multiple inputs, place a check mark beside the target inputs to set. To select and set all inputs, place a check mark in the Select All checkbox. 3 Adjust the conversion method. To set the up-converter conversion mode Press the [Conversion] button and select a conversion mode from the pull-down list. 369