Sony MLS-X1 Users Guide - Page 136

1 Press the [M/E-1] button, turning it on. 2 Press the [KEY1] button, turning it on. 3 Select a DME channel to assign using the DME channel selection buttons (DME1 to DME4). When using two DME channels Press the [DME1] button and [DME2] button, the [DME2] button and [DME3] button, or the [DME3] button and [DME4] button, turning them on. When using three DME channels Press the [DME1] button, [DME2] button, and [DME3] button, or the [DME2] button, [DME3] button, and [DME4] button, turning them on. When using four DME channels Press the [DME1] button, [DME2] button, [DME3] button, and [DME4] button, turning them on. Selecting a DME channel signal Select the following signals on the 1st channel to 4th channel. For details about selecting a signal, see "Chapter 4 Selecting Signals" (page 81). 1st channel signal: Key bus signal 2nd channel signal: DME external video bus signal 3rd channel signal: DME utility 1 bus signal 4th channel signal: DME utility 2 bus signal Assigning to DME monitor outputs 1 Press the [M/E-1] button, turning it on. 2 Press the [KEY1] button, turning it on. 3 Press and hold the [MON] button and press the button for a DME channel (DME1 to DME4) to assign. Only DME channels assigned to the selected key can be selected. The output of the selected DME channel is assigned to the monitor output (DME MON V and DME MON K). To check the status of the DME monitor output You can check the status of the monitor output by the lit color of the [DME1] button to [DME4] button while the [MON] button is pressed. Lit green: DME channel which is currently assigned to the monitor output. Lit amber: DME channel which can be assigned to the monitor output. Other Settings Blink There are two types of blinks. Key blink: The key is turned on and off at fixed intervals. You can set the blinking cycle time, and the proportion of each cycle for which the key is on and off. Edge blink: The key fill and key edge fill are interchanged at regular intervals. You can set the blinking cycle time, and the proportion of each cycle that the original state is interchanged. This section describes the M/E-1 key 1 menu as an example. Setting blinking 1 Open the Home > M/E-1 > Key1 > Type > Type Select menu (11101.11). 2 In the [Blink] group, select a blink type. Key Blink: Key blink Edge Blink: Edge blink When the [Key Blink] button is selected, set the following parameters. No. Parameter 1 Blink Rate 2 Duty Adjustment Length of blink cycle On/off proportion of each cycle When the [Edge Blink] button is selected, set the following parameters. No. Parameter 1 Blink Rate 2 Duty Adjustment Length of blink cycle Interchange proportion of each cycle Video Process The video process function adjusts the luminance and hue of the key fill signal. This section describes the M/E-1 key 1 menu as an example. Setting the video process function 1 Open the Home > M/E-1 > Key1 > Type > Type Select menu (11101.11). 136