Sony MLS-X1 Users Guide - Page 325
Displaying a Macro Attachment List, Setting the macro attachment, configuration mode of a cross-point
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 325 highlights
To release a macro attachment set to a fader lever Press and hold the [PRE MACRO] button or [POST MACRO] button in the cross-point control block and press the [LIMIT SET] button or [PRIOR SET] button in the transition control block/transition control block (simple type). Note You can also release a macro attachment setting using the menu. For details, see "Displaying a Macro Attachment List" (page 325). Setting the macro attachment configuration mode of a cross-point button The following two modes can be selected for a macro attachment set to a cross-point button. Button number mode: Assign a macro attachment for the combination of bus and button number. Pair number mode: Assign a macro attachment for the combination of bus and logical V/K pair number. Notes • If the macro attachment configuration mode is changed, the macro attachment assigned to a cross-point button is deleted. • In pair number mode, the following occurs. - If the same logical V/K pair number is assigned to multiple cross-point buttons, pressing one of the buttons executes the macros of all buttons to which the same logical V/K pair number is assigned. - If the same logical V/K pair number is assigned to multiple cross-point buttons, releasing the macro attachment of one of the buttons releases the macro attachment of all buttons to which the same logical V/K pair number is assigned. - If you change the logical V/K pair number assignment to a different cross-point button, the macro attachment setting is also transferred. • When macro attachment data is loaded, the button number mode or pair number mode setting is overwritten. 1 Open the Home > Register > Macro > Attachment menu (18307.31). 2 In the [Xpt Attachment Mode] group, select a configuration mode. Button Mode: Button number mode Pair Mode: Pair number mode 3 Check the message, then press [OK]. Displaying a Macro Attachment List You can check the information for a button/fader lever to which a macro attachment is set in list view. 1 Open the Home > Register > Macro > Attachment menu (18307.31). 2 Display the target control block. Select a tab to change the control block to display. [M/E-1] tab to [M/E-5] tab, [P/P] tab: Switcher bank cross-point control block and transition control block/transition control block (simple type)/independent key transition control block [Aux] tab: AUX bus control block (ICP-X7000 only) [Trackball] tab: Device control block (ICP-X1000 series only) [Trackball/Key Fader] tab: Device control block and key fader control block (ICP-X7000 only) A list of the macro attachments set to the buttons of the selected control block is displayed. You can check the following information in a macro attachment list. • Block name Displays the name of the control block on which macro attachments are set. • Buttons to which a macro attachment is set • Register number • Register name • Link mode For details about macro attachment lists, see "Macro Attachment Lists" (page 525). Note Macro attachments set to the following buttons in the cross-point control block may not be displayed in the list. • DME utility 1 bus and 2 bus cross-point buttons in utility bus mode • DME utility 1 bus and 2 bus cross-point buttons in key/ AUX bus delegation mode Releasing a macro attachment 1 Open the Home > Register > Macro > Attachment menu (18307.31). 2 Display the target control block. Select a tab to change the control block to display. 325