Sony MLS-X1 Users Guide - Page 392
Assigning a Multi Viewer Channel, Displaying a signal name, Displaying an audio level meter
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 392 highlights
[Input 101-150] tabs: Input signals 101 to 150 [Input 151-160] tabs: Input signals 151 to 160 [Clock] tab: Clock For details about the [Clock] tab, see "Displaying a clock" (page 392). Note Box input signals that are not configured in the switcher are not displayed. 5 Press [OK]. Displaying a signal name You can display the name of a signal assigned to a subscreen. 1 Open the Home > Setup > Switcher > Multi Viewer > Config menu (19103.21). 2 Display the target multi viewer to set. Select a tab to change the multi viewer to display. [MV1] tab: Multi viewer 1 [MV2] tab: Multi viewer 2 [MV3] tab: Multi viewer 3 [MV4] tab: Multi viewer 4 3 Press overflow button) on the right of the target subscreen to set. The [Select Displayed Information] window appears. 4 Place a check mark in [Name]. To not display a signal name, clear the check mark. To display the signal names of all subscreens Set the [Enable All Names] button to the on state. Displaying an audio level meter Notes • An audio level meter can be set only for channels with Enhanced MV assigned. • An audio level meter is not supported on a cross-point box multi viewer. 1 Open the Home > Setup > Switcher > Multi Viewer > Config menu (19103.21). 2 Display the target multi viewer to set. Select a tab to change the multi viewer to display. [MV1] tab: Multi viewer 1 [MV2] tab: Multi viewer 2 [MV3] tab: Multi viewer 3 [MV4] tab: Multi viewer 4 3 Press overflow button) on the right of the target subscreen to set. The [Select Displayed Information] window appears. 4 Place a check mark in [Audio Level Meter]. To not display the audio level meter, clear the check mark. To display the audio level meter of all subscreens Set the [Enable All Audio Meters] button to the on state. Displaying a clock You can display a clock in a multi viewer subscreen. Notes • A clock can be set only for channels with Enhanced MV assigned. • Only one subscreen can be configured with a clock. 1 Open the Home > Setup > Switcher > Multi Viewer > Config menu (19103.21). 2 Display the target multi viewer to set. Select a tab to change the multi viewer to display. [MV1] tab: Multi viewer 1 [MV2] tab: Multi viewer 2 [MV3] tab: Multi viewer 3 [MV4] tab: Multi viewer 4 3 Press the button for the target subscreen to set. The [Select Displayed Signal] window appears. 4 Set the button for the target clock to the on state. Analog: Analog clock Digital: Digital clock 5 Press [OK]. Assigning a Multi Viewer Channel You can set a hardware block (physical block) of the switcher for a multi viewer and assign it to a channel. For details about setting a multi viewer, see "Setting a Switcher Bank/Multi Viewer" (page 363). 392