Sony MLS-X1 Users Guide - Page 62
AC IN A, B, C, D connectors, REF OUT connector BNC type
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
d LAN 1 connector (RJ-45, 1000BASE-T compliant) LAN connector for standard interface 1. Used to control devices connected to the network of the switcher system. e LAN 2 connector (RJ-45, 1000BASE-T compliant) LAN connector for standard interface 2. Used to connect with an external network. f REF connectors (BNC type) Connect to a tri-level sync signal or black burst signal when using the unit synchronized to an external reference signal. The two connectors are loop-through connectors. Whichever is used as the input signal, the other can be used as an output signal. When not using loop-through, terminate the unused connector using a 75 ohm terminator. g REF OUT connector (BNC type) Outputs the internal reference signal when an external reference signal is not being used. h connector (USB 3.0, Type A) Connect to a USB device such as a USB drive or keyboard. i connector (USB 2.0, Type A) Connect to a USB device such as a USB drive or keyboard. j U (signal ground) terminal Connect to a ground wire. k AC IN A, B, C, D connectors Connect to an AC power supply using an AC power cord (sold separately). l GPI 1 and 2 connectors (D-sub 25-pin) Can be used when an MKS-X1700 Legacy Interface Board (option) is installed. Used as a GPI input port and GPI output port. Can also be used as a tally input/output port. m Network expansion 4 connector n Network expansion 3 connector o Network expansion 2 connector p Network expansion 1 connector PCIe slot. Supports third-party network expansion cards. Used as interface expansion 1 to 4 LAN connectors. The connectors are numbered 1 to 4 or 4 to 1 depending on the product. For details about recommended products, consult your Sony representative. For details, see "Configuring Box Network Settings" (page 470). q REMOTE 1/2, 3/4, 5/6, 7/8 connectors (RJ-45, RS-422 compliant) Can be used when an MKS-X1700 Legacy Interface Board (option) is installed. Connect to a device that supports VTR (Sony 9-pin VTR protocol), disk recorder (Video Disk Communications Protocol, Odetics protocol), or P-Bus (Peripheral Bus II protocol) protocols. Can also be used as a tally output port. 62