Sony MLS-X1 Users Guide - Page 110
Setting the independent key transition, type Flexi Pad control block, type menu
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Note When an operation mode that supports configuration of transitions where keys are inserted/removed independently is set, the transition type for inserting and removing keys can be set separately. For details about independent key transition operation mode, see "Setting the Independent Key Transition Mode" (page 394). Setting the independent key transition type (Flexi Pad control block) You can set the independent key transition type using the Flexi Pad control block of the target switcher bank. 1 Press the [KEY] button. The memory recall section switches to key operation mode. 2 Select the target key to set. Press a [KEY1] to [KEY8] button, turning it on. 3 Select a transition type. Press the [MIX] button, [WIPE] button, or [DME WIPE] button, turning it on. In operation modes that support configuration of transitions separately for when keys are inserted/ removed, configuration while a key is not inserted sets the transition type for key insertion and configuration while a key is inserted sets the transition type for key removal. 4 Set the transition type. Make the required settings for the selected transition type. When a mix, wipe, or DME wipe is selected Set the transition rate. For details about the transition rate, see "Setting the Independent Key Transition Rate" (page 111). When a wipe is selected Set the wipe pattern. For details, see "Setting an Independent Key Transition Wipe" (page 158). When a DME wipe is selected Set the DME wipe pattern. For details, see "Setting an Independent Key Transition DME Wipe" (page 170). Setting the independent key transition type (key fader control block) You can set the independent key transition type for a key assigned to a key delegation button. For details about assigning key delegation buttons, see "Assigning Control Panel Buttons" (page 402). 1 Select the target key to set. Press a key delegation button, turning it on. 2 Select a transition type. Press the [MIX] button, [WIPE] button, [DME WIPE] button, or [CUT] button, turning it on. In operation modes that support configuration of transitions separately for when keys are inserted/ removed, configuration while a key is not inserted sets the transition type for key insertion and configuration while a key is inserted sets the transition type for key removal. When you press and hold the [SHIFT] button and press the independent key transition type selection button, you can set the transition type for key removal while a key is not inserted and the transition type for key insertion while a key is inserted. 3 Set the transition type. Make the required settings for the selected transition type. When a mix, wipe, or DME wipe is selected Set the transition rate. For details about the transition rate, see "Setting the Independent Key Transition Rate" (page 111). When a wipe is selected Set the wipe pattern. For details, see "Setting an Independent Key Transition Wipe" (page 158). When a DME wipe is selected Set the DME wipe pattern. For details, see "Setting an Independent Key Transition DME Wipe" (page 170). Setting the independent key transition type (menu) This section describes the M/E-1 key 1 menu as an example. 1 Open the Home > M/E-1 > Key1 > Transition > Transition Type menu (11101.51). 110