Sony MLS-X1 Users Guide - Page 145

1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Enhanced Effect menu (11101.42). 2 Set the [Resizer] button to the on state. 3 Set the [Dual Rszr Effect] button to the on state. 4 Set the [Mask] button to the on state. 5 In the [Mask Source] group, select a mask source. Box: Box Circle: Circle Set the following parameters. No. Parameter 1 H 2 V 3 Size 4 Soft 5 Aspect Adjustment Horizontal position Vertical position Size Softness Aspect ratio To rotate a mask pattern In the [Rotation] group, select a rotation type. Angle: Incline a pattern at a fixed angle. Speed: Rotate a pattern at a fixed speed. When the [Angle] button is selected, set the following parameter. No. Parameter 1 Angle Adjustment Inclination angle of pattern • A value of -1.00 corresponds to a rotation of one turn counterclockwise. • A value of +1.00 corresponds to a rotation of one turn clockwise. • A value of 0.00 corresponds to no rotation. When the [Speed] button is selected, set the following parameter. No. Parameter 1 Speed Adjustment Rotation speed of pattern • A value of -100.00 corresponds to 4 revolutions/second counterclockwise rotation. • A value of +100.00 corresponds to 4 revolutions/ second clockwise rotation. • A value of 0.00 corresponds to no rotation (stationary). To invert a mask area Set the [Mask Invert] button to the on state. Key Snapshots You can save key settings (excluding key inserted/ removed (on/off) status and key priority) in a register and recall the settings when required. Settings information of cross-points, key modifiers, and independent key transitions can be selected and recalled. There are four key snapshot registers for each key. For details about editing a key snapshot register, see "Key Snapshot Register Operations" (page 289). Saving and recalling a key snapshot can be performed using the Flexi Pad control block, key fader control block, or the menu. Key Snapshot Operations (Flexi Pad Control Block) You can configure a key snapshot using the Flexi Pad control block of the target switcher bank. This section describes setting a key snapshot on key 1 as an example. Memory recall section in key snapshot operation mode Pressing the [KEY] button in the Flexi Pad control block switches the memory recall section to key operation mode. You can select key snapshot registers (1 to 4) using the buttons in the memory recall section. The register name is displayed on buttons for registers with a registered snapshot. The register number is displayed on buttons for registers without a registered snapshot. The button color varies as follows, according to the register state. Gray characters: Register not containing a registered snapshot White characters: Register containing a registered snapshot Lit orange: Last recalled register Saving a key snapshot Set a key and save a key snapshot register using the following procedure. 1 Press the [KEY] button. The memory recall section switches to key operation mode. 145