Sony MLS-X1 Users Guide - Page 214

No. Parameter 1 Top 2 Left 3 Right 4 Bottom Adjustment Position of top edge Position of left edge Position of right edge Position of bottom edge 4 In the [Side H Rotation] group, set the angle of rotation of the image on side H. 0: No rotation 90: 90° rotation 180: 180° rotation 270: 270° rotation 5 In the [Side V] group, select how to fit the image on side V. Configure in the same way as for side H. 6 In the [Side V Rotation] group, set the angle of rotation of the image on side V. Configure in the same way as for side H. To invert the image on the front side In the [Side H Front] group for side H or [Side V Front] group for side V, select the direction of inversion. Invert H: Invert horizontally. Invert V: Invert vertically. To invert the image on the back side In the [Side H Back] group for side H or [Side V Back] group for side V, select the direction of inversion. Invert H: Invert horizontally. Invert V: Invert vertically. Setting a Shadow You can add a shadow to the image using two DME channels. The channel with the higher number from among the two channels is used as the shadow. The following channels can be used as the shadow, depending on which channels (Ch1 to Ch4) are combined. a: Shadow can be set Channel Shadow setting Ch1 Ch2 Ch3 Ch1 + Ch2 Ch2 + Ch3 Ch1 + Ch2 a - - - - Ch2 + Ch3 - a- - - Ch3 + Ch4 - - a- - Ch1 + Ch2, a - a- - Ch3 + Ch4 Channel Shadow setting Ch1 Ch2 Ch3 Ch1 + Ch2 a a - + Ch3 Ch2 + Ch3 - + Ch4 aa Ch1 + Ch2 a a a + Ch3 + Ch4 Ch1 + Ch2 Ch2 + Ch3 a - - a a - This section describes setting a shadow on channel 1 as an example. 1 Open the Home > DME > Global Effect > Shadow menu (15109.31). 2 Set the [Ch 1 Shadow] button to the on state and set the following parameters. No. Parameter 1 Position H 2 Position V 3 Density Adjustment Shadow position in the horizontal direction Shadow position in the vertical direction Density of shadow 3 In the [Ch 1 Shadow Source] group, select a signal to insert in the shadow. Video: Channel 2 input video signal Flat Color: Single color When the [Flat Color] button is selected, set the following parameters. No. Parameter 1 Luminance 2 Saturation 3 Hue Adjustment Luminance Saturation Hue To set a shadow on a channel other than channel 1, do the following. To set a shadow on channel 2: Set using the [Ch 2 Shadow] button and [Ch 2 Shadow Source] group. Channel 3 is used as the shadow. To set a shadow on channel 3: Set using the [Ch 3 Shadow] button and [Ch 3 Shadow Source] group. Channel 4 is used as the shadow. Setting a shadow using channels 1 to 3 (Ch1 + Ch2 + Ch3) Set a "Ch1 + Ch2 + Ch3" combine, set the [Ch 1 + Ch 2 Shadow] button to the on state, and perform the following. 214