Sony MLS-X1 Users Guide - Page 102

In frame number input mode, enter three digits. In timecode input mode, enter four digits. To delete the entered value Press the [CLR] button. Note You can also enter a difference value from the currently set value using the [TRIM] button. For details, see "Entering a difference from a current value" (page 79). 4 Press the [ENTER] button. The entry is applied and the set value is reflected on the memory recall button in the utility/shotbox control block. Setting the transition rate (menu) This section describes the M/E-1 menu as an example. 1 Open the Home > M/E-1 > Bus/Transition > Transition > Transition Type menu (11109.21). 2 Select a transition type in the [Transition Type] group. 3 Set the transition rate using the following parameter. No. Parameter Adjustment 1 Transition Rate Transition rate To set the transition rate in list view You can set the transition rate in transition rate list view on each switcher bank. 1 Open the Home > Utility > Transition Rate menu (18201.21). The transition rate for common transitions and independent key transitions is displayed for each switcher bank. 2 Select the target switcher bank to set. 3 Press the [Common] button and enter a transition rate in the numeric keypad window. In multi program 2 mode, enter a transition rate for main using the [Common] button, and a transition rate for sub using the [Sub Common] button. Executing a Transition Transitions are executed using the transition control block or simple-type transition control block. You can also execute auto transitions using the menu. Note In the simple-type transition control block, only background transition operations are supported. The buttons used for executing a transition must be assigned to the transition control block (simple type) beforehand. For details about assigning buttons, see "Assigning Control Panel Buttons" (page 402). ICP-X7000 transition control block CUT button Fader lever AUTO TRANS button Transition indicator 102