Sony MLS-X1 Users Guide - Page 168
Displaying/moving the DME wipe pattern, position Position Select
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
3 Set the [Position] button in the [Position] group to the on state and set the following parameters. No. Parameter 1 H a) 2 V Adjustment Horizontal position • Negative values move left. • Positive values move right. Vertical position • Negative values move down. • Positive values move up. a) Not displayed when a 2-channel mode Brick pattern (pattern numbers 2801 to 2804, 2811 to 2814) is selected. When a 2-channel mode P in P pattern (pattern numbers 2651, 2652) is selected, set the relative position using the following parameters. No. Parameter 4 Relative H 5 Relative V Adjustment Relative position in the horizontal direction Relative position in the vertical direction To return the pattern position to the center of the screen Press the [Center] button in the [Position] group. Displaying/moving the DME wipe pattern position (Position Select) 1 Open the Home > M/E-1 > Bus/Transition > DME Wipe > Modify menu (11109.45). 2 In the [Ch Select] group, select the target DME channel to set. 3 In the [Position Select] group, select a move position. Top Left: Top left corner Top Right: Top right corner Bottom Left: Bottom left corner Bottom Right: Bottom right corner The button for the current pattern position is in the on state. When the pattern position is at the center of the screen, all four buttons are in the on state. Note When multiple channels are selected, the 1st channel becomes the target for movement. Setting the DME wipe pattern size (Size) 1 Open the Home > M/E-1 > Bus/Transition > DME Wipe > Modify menu (11109.45). 2 In the [Ch Select] group, select the target DME channel to set. 3 Set the [Size] button to the on state and set the following parameter. No. Parameter 1 Size Adjustment Size Note When multiple channels are selected, the setting values for the channel with the lowest number are displayed. When you adjust the setting values, this adjusts the settings on the other channels by the same amount. Setting the DME wipe pattern cropping (Crop) 1 Open the Home > M/E-1 > Bus/Transition > DME Wipe > Modify menu (11109.45). 2 In the [Ch Select] group, select the target DME channel to set. 3 Set the [Crop] button in the [Crop Mode] group to the on state and set the following parameters. No. Parameter 1-1 H 1-2 V 1-3 All 2-1 Top 2-2 Left 2-3 Right 2-4 Bottom Adjustment Simultaneous adjustment of crop of left and right edges Simultaneous adjustment of crop of top and bottom edges Simultaneous adjustment of crop of top, bottom, left, and right edges Crop of top edge Crop of left edge Crop of right edge Crop of bottom edge Note When multiple channels are selected, the setting values for the channel with the lowest number are displayed. When you adjust the setting values, this adjusts the settings on the other channels by the same amount. To crop to 4:3 aspect ratio Press the [4:3 Crop] button in the [Crop Mode] group. To set the movement during transition execution In the [Crop Transition] group, select the crop operation as the transition executes. 168