Sony MLS-X1 Users Guide - Page 388
Setting the Operation Mode and, Output for a Switcher Bank, Setting the output configuration
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 388 highlights
2 Select the [Logical Box ID] tab, switch boxes, and select the target physical M/E block/sub block to set. 3 Set the [SL Key] switch to the on state. To disable an SL key, set the [SL Key] switch to the off state. Setting the Operation Mode and Output for a Switcher Bank Setting the operation mode You can select from the following four operation modes for each switcher bank. Standard mode Four outputs are assigned as follows (fixed). Out1: Program 1 output Out2: Preview 1 output Out3: Clean output Out4: Key preview 1 output Multi program mode Up to eight outputs can be used. Out1: Program 1 output (fixed) is assigned. Out2 to Out8: You can assign the following outputs. Program 1 to 4 outputs Preview 1 output Clean output Key preview 1 and 2 outputs When M/E split is enabled, Out5 to Out8 cannot be used. Multi program 2 mode Up to eight outputs can be used. Out1: Program 1 output (fixed) is assigned. Out2 to Out8: You can assign the following outputs. Program 1 to 4 outputs Preview 1 and 2 outputs Clean output Sub clean output Key preview 1 and 2 outputs DSK mode Six outputs are assigned as follows (fixed). Out1: Program 1 output Out2: Program 2 output Out3: Program 3 output Out4: Program 4 output Out5: Key preview 1 output Out6: Key preview 2 output When M/E split is enabled, four outputs are assigned as follows (fixed). Out1: Program 1 output Out2: Program 2 output Out3: Key preview 1 output Out4: Key preview 2 output Notes • When M/E split is enabled, multi program 2 mode cannot be selected. • DSK mode can be selected only when the switcher bank is assigned to P/P. 1 Open the Home > Setup > Switcher > Config > M/E Config menu (19103.12). 2 Select the target switcher bank to set. 3 Press the [M/E Config] button and select an operation mode from the pull-down list. Standard: Standard mode Multi Program: Multi program mode Multi Program 2: Multi program 2 mode DSK: DSK mode Setting the output configuration You can set the output signal configuration of a switcher bank when in multi program mode or multi program 2 mode. Notes • The output configuration for standard mode and DSK mode cannot be changed. • Out1 is set to PGM1 (fixed). • When M/E split is enabled, Out5 to Out8 cannot be used. 1 Open the Home > Setup > Switcher > Config > M/E Config menu (19103.12). 2 Select the target switcher bank to set. 3 Press the [Edit] button for [Output]. The [Output] window appears. 4 Press the button for the target output number (1 to 8) and select an output signal from the pull-down list. 5 Press [OK]. Setting the program output You can select the background and the keys to enable for the program output. 1 Open the Home > Setup > Switcher > Config > PGM Config menu (19103.13). 2 Select the target program output to set. 388