Sony MLS-X1 Users Guide - Page 417
Setting the Transition Operation, Buttons and Display Mode, button is pressed during fade-to-black
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 417 highlights
Notes • Line breaks in names are enabled only when [Auto] is selected. • Up to two lines are displayed when the display mode is set to split display. Enabling the alias name link function When the link function is enabled, you can replace a source name set on the switcher with an NS-Bus alias name set in LSM. The source name is updated each time the alias name is updated. This allows you to always use the same name between LSM and the switcher. The NS-Bus alias name is reflected in the source name setting in the Home > Setup > System menu, hence the name set in LSM is also displayed when the [Sw'er Local] button in the [Source/Dest Name] group is set to the on state. Notes • When the [NS-Bus Name Link] button is set to the on state, the settings of all source names for the switcher (including wiring traceback), not just in the Home > Setup > System menu, are always replaced by the NSBus alias name. • To display the NS-Bus alias name on a multi viewer subscreen, you must set the [NS-Bus Alias] button in the [Source/Dest Name] group to the on state and set the [NS-Bus Name Link] button to the on state. 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 Set the [NS-Bus Name Link] button to the on state. 3 Check the message, then press [OK]. Setting the Transition Operation Buttons and Display Mode Setting the transition rate display 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 In the [Trans Rate Display] group, select a display mode. Frame: Display as number of frames. Timecode: Display as timecode. Setting the operation when the [FTB] button is pressed during fade-to-black 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 In the [FTB] group, select an operation mode. Continue: Continue the transition. Cancel: Cancel the transition and return to the previous state before executing fade-to-black. Setting the independent key transition, auto transition execution button display ICP-X7000 configuration Note Enabled using the [AUTO TRANS] button in the independent key transition execution section of the transition control block, independent key transition control block, and key fader control block. 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 In the [Auto Trans Key On Status] group, select a display mode. Disable: Lit amber during transition execution, and goes off at the end of the transition. Enable: Lit green during transition execution, and at the end of the transition it is lit red if on-air or lit amber if not on-air. ICP-X1000 series configuration Note Enabled using a [KEY1 TRANS] to [KEY8 TRANS] button in the independent key transition execution section of the transition control block. 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 In the [Key Trans On Status] group, select a display mode. Disable: Lit amber during transition execution, and goes off at the end of the transition. Enable: Lit green during transition execution, and at the end of the transition it is lit red if on-air or lit amber if not on-air. 417